Lc29h Rtk. LC29H Series Dualband GPS Module for Raspberry Pi, Dualband L1+L5 Dual band (L1+L5) high precision GNSS with 10Hz RTK and dual antenna heading functions: LC29H (BS) Dual band (L1+L5) base station module, support raw measurements output only: Simplify deployment by sourcing antennas at the same time as your modules - see our wide range here and web browser as a way to send P2P RTCM correction from base to rover.
LC29HModuleRTKDifferentialGPSBeidouGNSSPositioningDual from www.aliexpress.com
If you are using an LC29H as a local base station, you will want to connect it to an NTRIP caster to broadcast the correction stream. As far as I understoon I just need to write the raw RTCM data from BS to DA (please note I check that the binary data starts with the appropriate marker 0xD3 and BS survey-in is completed)
Simple RTK base/rover setup using LC29H modules from Waveshare LC29H(BA,CA,DA)_DR&RTK_Application_Note 11 / 31 Step 2: Calibration should be performed under good GNSS signal and clear sky conditions Adopts dual-band positioning and RTK technology to meet the need of centimeter-level high-precision.
LC29H Series Dualband GPS Module for Raspberry Pi, Dualband L1+L5. With built-in LNA and SAW filter to achieve high sensitivity and strong anti-interference capability Dual band (L1+L5) high precision GNSS with 10Hz RTK and dual antenna heading functions: LC29H (BS) Dual band (L1+L5) base station module, support raw measurements output only: Simplify deployment by sourcing antennas at the same time as your modules - see our wide range here
HYFIX.AI announces availability of its Mobile Centimeter base. LC29H(DA) - Supports RTK Rover to realize high-precision centimeter-level positioning I bought the LC29H(DA) and LC29H(BS) (from waveshare store) and try to setup the RTK configuration